From: Mesut Abdurrahmani (mesut@kujtesa.com)
Date: Tue Feb 01 2005 - 18:42:56 GMT-3
Brian,
Thanks for you quick response. I've configured reflector-port on a port that
is not active, switch gives the green light on that port ( I think it is
looped) but still can't sniff the information on Switch A ( source switch).
Other configuration is the same except the reflector-port. Is there any
possibility of a bug on catalyst 2950 switches?
Thanks
Best regards
Mesut Abdurrahmani
-----Original Message-----
From: Brian McGahan [mailto:bmcgahan@internetworkexpert.com]
Sent: Tuesday, February 01, 2005 9:52 PM
To: Mesut Abdurrahmani; ccielab@groupstudy.com
Subject: RE: Remote SPAN Question
Mesut,
The reflector port should not be an active interface. In order
to run RSPAN you must dedicate one interface to be the reflector port.
Change it to something else besides fa0/5 and it should work.
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Mesut Abdurrahmani
> Sent: Tuesday, February 01, 2005 2:23 PM
> To: ccielab@groupstudy.com
> Subject: Remote SPAN Question
>
> Hi
>
>
>
> I'm trying to implement Remote SPAN feature on my 2 x 2950 but wasn't
> successful till now. I have created a Remote Span Vlan on both
switches
> (VLAN 6), switches are interconnected through a trunk (Fa0/5). On
source
> switch I've used the following commands
>
>
>
> Monitor session 1 source interface fa0/6 - 24 tx
>
> Monitor session 1 destination remote vlan 6 reflector-port fa0/5
>
>
>
> And on destination switch
>
>
>
> Monitor session 1 source remote vlan 6
>
> Monitor session 1 destination interface fa0/24
>
>
>
> There are no access ports that use vlan 6 (RSPAN VLAN )as it meant to
be
> and
> all I've disabled Pruning on Vlan 6.
>
>
>
> The Reflector-port (fa0/5) on switch A and destination interface on
Switch
> B
> (fa0/24) goes on monitoring state, which is OK
>
> FastEthernet0/24 is down, line protocol is down (monitoring)
>
>
>
> Hope to get help
>
>
>
> Thanks in Advance,
>
> Regards,
>
> Mesut Abdurrahmani
>
>
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:15 GMT-3