From: asfar sayed (cityworm@rediffmail.com)
Date: Fri Nov 19 2004 - 03:38:33 GMT-3
Hi Group study
I need to know how do i apply CBWFQ to an ATM SVC
interface
and how do i convert Byte count from CQ to bandwidth percent in
CBWFQ
please help
Asfar
On Sat, 06 Nov 2004 Cisco Net wrote :
>Hi
>In
order to specify the bandwith to specify under cb-wfq we have two ways,
>1-
bandwidth percentage
>2- bandiwth in Kbps
>
>When i convert custom q to cb-wfq
i can conver to either BPS or percentage.
>In both the case i need to find the
value,
>As per the documentation,
>1-To calculate BPS valus = (queue byte
count / total byte count of all
>queues) * bandwidth capacity of the interface
>2-To calculate bandwidth percentage value = (queue byte count / total
>byte
count of all queues) * 100
>
>total byte count is calculated by adding all the
q-list byte-count.
>Somebody please verify these...
>
>a) The other question
is if i have an entry for "default queue" within
>custom queue, should i
assume 1500 bytes as the byte count and add
>this as well when i have to find
the total queue to calculate the
>percentage or bps value as showed above.
>
>queue-list 10 default 2
>
>b) How about if a queue list entry that is not
defined for byte-count
>vlaue, when i calculate the total byte count should i
assume the
>default value (1500).
>Regards
>Cert
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:47 GMT-3