From: Anand Singh (anandksi@cisco.com)
Date: Mon Oct 11 2004 - 12:49:15 GMT-3
Mark,
I forgot to mention that I tested and both of these command's work.
-Anand
> -----Original Message-----
> From: Campbell, Mark [mailto:campbell.mark@siemens.com]
> Sent: Monday, October 11, 2004 8:23 AM
> To: Anand Singh; ccielab@groupstudy.com
> Subject: RE: Forward all voip traffic to gateway
>
>
> Hi Anand,
>
> The best way test this would be to "debug dialpeer" and do
> "csim start
> (random number)" and see if there's a match to the dial-peer
> voice instance you used .% in...(otherwise just use your
> phone instead of
> csim.)
>
> Regards,
> Mark
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of Anand Singh
> Sent: Monday, October 11, 2004 4:22 PM
> To: ccielab@groupstudy.com
> Subject: Forward all voip traffic to gateway
>
> Hello All,
>
> If i have to configure router to forward all voip traffic to
> the voice gateway, can i use the following config:
>
> dial-peer voice 3 voip
> destination-pattern .%
> session target ipv4:3.3.3.3
> !
>
> What' the difference between this and using
> "destination-pattern .T". I know later will tell router to
> wait for interdigit timeout before placing the call but is
> both config valid for above requirement?
>
>
> Thanks
> -Anand
>
> ______________________________________________________________
> _________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:46 GMT-3