From: samccie2004@yahoo.co.uk
Date: Thu Sep 23 2004 - 14:47:35 GMT-3
Remove "down-when-looped", if it shows looped then this confirms what
Joseph has already suggested.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joseph D. Phillips
Sent: 23 September 2004 18:41
To: Sharma Sham Sunder (vMoksha)
Cc: group study
Subject: Re: FW: Serial 2/1:0 is reset, line protocol is down
Maybe your provider is doing a loopback test.
On Thu, 23 Sep 2004 18:35:38 +0200, "Sharma Sham Sunder (vMoksha)"
<ShamSunder.Sharma@UCB-Group.com> said:
> This is interface config.there is no config done on the Serial2/1
>
> interface Serial2/1:0
> description ### LEASED LINE 1536KB TO BIRMINGHAM ###
> bandwidth 1536
> ip address 192.192.192.30 255.255.255.252
> ip accounting output-packets
> down-when-looped
> no cdp enable
>
> CSATLANTA1#sh int serial 2/1:0
> Serial2/1:0 is reset, line protocol is down
> Hardware is DSX1
> Description: ### LEASED LINE 1536KB TO CSBIRMINGHAM ###
> Internet address is 192.168.254.13/30
> MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation HDLC, loopback not set
> Keepalive set (10 sec)
> Last input 00:26:35, output 00:26:33, output hang never
> Last clearing of "show interface" counters 00:09:57
> Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
80
> Queueing strategy: weighted fair
> Output queue: 0/1000/64/0 (size/max total/threshold/drops)
> Conversations 0/30/256 (active/max active/max total)
> Reserved Conversations 0/0 (allocated/max allocated)
> Available Bandwidth 1152 kilobits/sec
> 5 minute input rate 0 bits/sec, 0 packets/sec
> 5 minute output rate 0 bits/sec, 0 packets/sec
> 0 packets input, 0 bytes, 0 no buffer
> Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
> 0 packets output, 0 bytes, 0 underruns
> 0 output errors, 0 collisions, 20 interface resets
> 0 output buffer failures, 0 output buffers swapped out
> 0 carrier transitions
> Timeslot(s) Used:1-24, Transmitter delay is 0 flags
> CSATLANTA1#
>
> Hi
>
> Can someone explain why i am getting it like this ..
>
> Serial 2/1:0 is reset, line protocol is down
>
> Thanks&Regards
>
>
> ---------------------------------------------------------
> Legal Notice: This electronic mail and its attachments are intended
> solely
> for the person(s) to whom they are addressed and contain information
> which
> is confidential or otherwise protected from disclosure, except for the
> purpose they are intended to. Dissemination, distribution, or
> reproduction
> by anyone other than their intended recipients is prohibited and may
be
> illegal. If you are not an intended recipient, please immediately
inform
> the
> sender and send him/her back the present e-mail and its attachments
and
> destroy any copies which may be in your possession.
> ---------------------------------------------------------
>
>
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:48 GMT-3