Frame-relay map

From: Nico van Niekerk (nico@vanniekerk.co.za)
Date: Mon Aug 30 2004 - 22:52:35 GMT-3

Next message: john matijevic: "RE: Cisco Press R&S Lab workbook - Clarification needed - ???"
Previous message: Vazman@aol.com: "Radius Authentication and Authorization question"
Next in thread: Nico van Niekerk: "RE: Frame-relay map"
Maybe reply: Nico van Niekerk: "RE: Frame-relay map"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This is a very basic question regarding frame-relay mapping:
Could anybody tell me why I get the following 2 map entries (in bold) ?

******************************
RouterA#sh frame map
Serial0 (up): ip 0.0.0.0 dlci 200(0xC8,0x3080)
              broadcast,
              CISCO, status defined, active
Serial0 (up): ip 0.0.0.0 dlci 100(0x64,0x1840)
              broadcast,
              CISCO, status defined, active
Serial0 (up): ip 192.1.1.3 dlci 100(0x64,0x1840), dynamic,
              broadcast,, status defined, active
Serial0 (up): ip 192.1.1.4 dlci 200(0xC8,0x3080), dynamic,
              broadcast,, status defined, active
*******************************

I don't have any static map statements under the interface.

Next message: john matijevic: "RE: Cisco Press R&S Lab workbook - Clarification needed - ???"
Previous message: Vazman@aol.com: "Radius Authentication and Authorization question"
Next in thread: Nico van Niekerk: "RE: Frame-relay map"
Maybe reply: Nico van Niekerk: "RE: Frame-relay map"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:50 GMT-3