From: Scott Morris (swm@emanon.com)
Date: Sat Aug 21 2004 - 23:00:02 GMT-3
Dialer-watch is the one thing that works independent of interesting traffic.
The fact that your route is down becomes "interesting" itself and your BRI
is brought up (providing you have the appropriate maps).
So if you are relying on dialer-watch, you do not need to have interesting
traffic.
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIP, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mathew
Sent: Saturday, August 21, 2004 9:54 PM
To: CCIE LAB List
Subject: dialer-list command with dialer-watch config
Hi,
In Karl Solie's Practical Studies book page 507 (chapter 7 under dialer
watch), he has used the below config;
access-list 101 deny eigrp any any
access-list 101 permit ip any any
dialer watch-list 1 ip 175.10.102.1 255.255.255.255 dialer watch-list 1 ip
175.10.1.0 255.255.255.0 dialer-list 1 protocol ip list 101
I use the same config with OSPF routing (1st line eigrp replaced with
ospf) and it worked.
Also when I used the below dialer-list command, then also it worked well.
dialer-list 1 protocol ip deny
Can some explain to me what is the difference? maybe I am missing something
in understanding the use of the "dialer-list" command with dialer watch.
mathew
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:47 GMT-3