DSLW BPDU + Lab config

From: alsontra@hotmail.com
Date: Sat Jul 24 2004 - 19:36:19 GMT-3

Next message: Shibu Nair: "Custom Q byte count to bandwidth percentage calculation"
Previous message: Brian Dennis: "RE: PPP CALLBACK WITH DIALER-WATCH!!!"
Next in thread: Dan Shechter: "Re: DSLW BPDU + Lab config"
Maybe reply: Dan Shechter: "Re: DSLW BPDU + Lab config"
Maybe reply: alsontra@hotmail.com: "Re: DSLW BPDU + Lab config"
Maybe reply: Geert Nijs: "RE: DSLW BPDU + Lab config"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Is there a "best way" to handle ports being used on 3350 as dlsw end points?
Suppose you have the following setup:

SW1 fa0/2---e0/0-R1-S0/0----------S0/0-R2-E0/0-----SW1 fa0/3

To prevent the interface from trying to trunk or entering an err-state, I 've
been using either bpdu-filter or sw mode access. Is there a better way to deal
with ports receiving bpdu's due to a dlsw configuration?

Thanks in advance,
Alsontra

Next message: Shibu Nair: "Custom Q byte count to bandwidth percentage calculation"
Previous message: Brian Dennis: "RE: PPP CALLBACK WITH DIALER-WATCH!!!"
Next in thread: Dan Shechter: "Re: DSLW BPDU + Lab config"
Maybe reply: Dan Shechter: "Re: DSLW BPDU + Lab config"
Maybe reply: alsontra@hotmail.com: "Re: DSLW BPDU + Lab config"
Maybe reply: Geert Nijs: "RE: DSLW BPDU + Lab config"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:12:02 GMT-3