Custom Q byte count to bandwidth percentage calculation

From: Shibu Nair (shinair@cisco.com)
Date: Sat Jul 24 2004 - 17:30:54 GMT-3

• Next message: Georg Pauwen: "Re: BGP Neighbor Specific Route"
• Previous message: alsontra@hotmail.com: "DSLW BPDU + Lab config"
• Next in thread: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: Shibu Nair: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Custom Q byte count to percentage calculation.

I have the below Qs,
Q1 1000 bytes
Q2 500 bytes
Q3 200 bytes.
None of the above Qs are default Q.

I want to convert into bandwidth in percentage.
Please let me know the values...

I know the first step is to add all the bytes. But my confusion is here.
In the question there is no default queue mentioned. But should i still
assume the default q and default byte-count of 1500 considered when
i add all the queues (will be total 4 queues then ?)

Shibu

• Next message: Georg Pauwen: "Re: BGP Neighbor Specific Route"
• Previous message: alsontra@hotmail.com: "DSLW BPDU + Lab config"
• Next in thread: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: Shibu Nair: "RE: Custom Q byte count to bandwidth percentage calculation"
• Maybe reply: john matijevic: "RE: Custom Q byte count to bandwidth percentage calculation"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:12:02 GMT-3