From: diptish doshi (diptishdoshi007@yahoo.com)
Date: Tue Jun 29 2004 - 16:52:51 GMT-3
hi bob ,
thanx for ur reply ,
i did change the hello timer and checked it by the
various show commands u have mentioned below ... but
none did reflect the changes i made on hello intervals
--- Bob Sinclair <bsin@cox.net> wrote:
> Diptish,
>
> The neighbor holdtime is supposed to be the product
> of the isis
> hello-multiplier (default 3) and the isis
> hello-interval (default 10 seconds
> on LAN). Apparently both of these numbers are sent
> to neighbors in the
> hellos. So making the hello interval smaller also
> tells the other side to
> make the holdtime smaller.
>
> Best commands for this are:
>
> sh clns interfaces
>
> sh clns neighbors detail (holdtime)
>
> sh clns is-neighbors detail
>
> HTH,
>
> Bob Sinclair
> CCIE #10427, CISSP, MCSE
> www.netmasterclass.net
>
> ----- Original Message -----
> From: "diptish doshi" <diptishdoshi007@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Tuesday, June 29, 2004 3:25 PM
> Subject: Verifying ISIS timers
>
>
> > hi all ,
> > Like in ospf we have command " show ip ospf
> > interface " to check the hello , holdtime , etc
> etc .
> > So as in RIP and BGP there are commands too ...
> > I didnt find any such command in ISIS to verify
> the
> > configured hello timers ...
> > Is there any such command ?? or i missed it ??
> >
> > regards ,
> > diptish .
> >
> >
> >
> > __________________________________
> > Do you Yahoo!?
> > New and Improved Yahoo! Mail - Send 10MB messages!
> > http://promotions.yahoo.com/new_mail
> >
> >
>
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:52 GMT-3