From: Bob Sinclair (bsin@cox.net)
Date: Tue Jun 29 2004 - 16:48:00 GMT-3
Diptish,
The neighbor holdtime is supposed to be the product of the isis
hello-multiplier (default 3) and the isis hello-interval (default 10 seconds
on LAN). Apparently both of these numbers are sent to neighbors in the
hellos. So making the hello interval smaller also tells the other side to
make the holdtime smaller.
Best commands for this are:
sh clns interfaces
sh clns neighbors detail (holdtime)
sh clns is-neighbors detail
HTH,
Bob Sinclair
CCIE #10427, CISSP, MCSE
www.netmasterclass.net
----- Original Message -----
From: "diptish doshi" <diptishdoshi007@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, June 29, 2004 3:25 PM
Subject: Verifying ISIS timers
> hi all ,
> Like in ospf we have command " show ip ospf
> interface " to check the hello , holdtime , etc etc .
> So as in RIP and BGP there are commands too ...
> I didnt find any such command in ISIS to verify the
> configured hello timers ...
> Is there any such command ?? or i missed it ??
>
> regards ,
> diptish .
>
>
>
> __________________________________
> Do you Yahoo!?
> New and Improved Yahoo! Mail - Send 10MB messages!
> http://promotions.yahoo.com/new_mail
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:52 GMT-3