port-channel config

From: samccie2004@yahoo.co.uk
Date: Thu Jun 03 2004 - 14:11:58 GMT-3

• Next message: Tylan Campbell: "Re: Fw: ISDN backup"
• Previous message: Sergio Jimenez Arguedas: "Fw: ISDN backup"
• Next in thread: ccie2be: "Re: port-channel config"
• Maybe reply: ccie2be: "Re: port-channel config"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi group

Just checking in order not too loose points.

Two switches must have etherchannel configured only SW1 can initiate
negotiation thru LACP.
1-What I am nearly sure about is that SW1 should have ether mode as active,
and SW2 as passive.
2-what I am not sure about is whether switchport mode trunk is needed or
not. Can I leave it as per default, ie dynamic desirable.

Many thanks

Sam

interface Port-channel20
 switchport trunk encapsulation dot1q
 switchport mode trunk
!
interface FastEthernet0/17
 switchport trunk encapsulation dot1q
 switchport mode trunk
 channel-group 20 mode active
!
interface FastEthernet0/18
 switchport trunk encapsulation dot1q
 switchport mode trunk
 channel-group 20 mode active

• Next message: Tylan Campbell: "Re: Fw: ISDN backup"
• Previous message: Sergio Jimenez Arguedas: "Fw: ISDN backup"
• Next in thread: ccie2be: "Re: port-channel config"
• Maybe reply: ccie2be: "Re: port-channel config"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:32 GMT-3