From: Sergio Jimenez Arguedas (sejimenez@its.co.cr)
Date: Sat May 08 2004 - 16:40:30 GMT-3
> Hi Bob,
>
> You are right!!!
>
> Thanks for your time anf help!!!
>
> Sergio
>
>
> ----- Original Message -----
> From: "Bob Sinclair" <bsin@cox.net>
> To: "Sergio Jimenez Arguedas" <sejimenez@its.co.cr>;
> <ccielab@groupstudy.com>
> Sent: Friday, May 07, 2004 8:49 PM
> Subject: Re: QoS Task Question?
>
>
> > Sergio,
> >
> > I find that the syntax will take a minimum burst of 1000 bytes, but as
> soon
> > as I apply it, the router barks and increases it the mtu, 1500 bytes,
> >
> > HTH,
> >
> > Bob Sinclair
> > CCIE #10427, CISSP, MCSE
> > www.netmasterclass.net
> >
> >
> > ----- Original Message -----
> > From: "Sergio Jimenez Arguedas" <sejimenez@its.co.cr>
> > To: <ccielab@groupstudy.com>
> > Sent: Friday, May 07, 2004 10:33 PM
> > Subject: QoS Task Question?
> >
> >
> > > Hi Group,
> > >
> > > I have a question of QoS!!!
> > >
> > > It is a task in DOiT Sample Scenario!!!
> > >
> > >
> > > It says:
> > >
> > > Limit the UDP traffic to 8000 bit/sec rate on the FE0/0 of R1.
CONFIGURE
> > THE
> > > MININAL VALUES FOR BURST SIZE AND EXTENDED BURST SIZE.
> > >
> > >
> > > The answers is:
> > >
> > > rate-limit input access-group 100 8000 1500 2000 conform-action
> transmit
> > > exceed-action drop
> > >
> > > But is think it is:
> > >
> > > rate-limit input access-group 100 8000 1000 2000 conform-action
> transmit
> > > exceed-action drop
> > >
> > > Because,,,,,
> > >
> > > R1(config-subif)# rate-limit input access-group 100 8000 1000 ?
> > > <2000-1024000000> Maximum burst bytes
> > >
> > > R1(config-subif)# rate-limit input access-group 100 8000 1000 2000 ?
> > > conform-action action when rate not exceeded
> > >
> > > R1(config-subif)# rate-limit input access-group 100 8000 1000 2000
> > >
> > >
> > > Is it a mistake in the practice?
> > >
> > >
> > > Rgds,
> > >
> > >
> > > Sergio Jiminez A.
> > >
> > >
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:07 GMT-3