QoS Task Question?

From: Sergio Jimenez Arguedas (sejimenez@its.co.cr)
Date: Fri May 07 2004 - 23:33:22 GMT-3

• Next message: Bob Sinclair: "Re: IP Multicast over FR!!!"
• Previous message: MMoniz: "RE: IP Multicast over FR!!!"
• Next in thread: Bob Sinclair: "Re: QoS Task Question?"
• Maybe reply: Bob Sinclair: "Re: QoS Task Question?"
• Maybe reply: Sergio Jimenez Arguedas: "Fw: QoS Task Question?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,

I have a question of QoS!!!

It is a task in DOiT Sample Scenario!!!

It says:

Limit the UDP traffic to 8000 bit/sec rate on the FE0/0 of R1. CONFIGURE THE
MININAL VALUES FOR BURST SIZE AND EXTENDED BURST SIZE.

The answers is:

 rate-limit input access-group 100 8000 1500 2000 conform-action transmit
exceed-action drop

But is think it is:

 rate-limit input access-group 100 8000 1000 2000 conform-action transmit
exceed-action drop

Because,,,,,

R1(config-subif)# rate-limit input access-group 100 8000 1000 ?
  <2000-1024000000> Maximum burst bytes

R1(config-subif)# rate-limit input access-group 100 8000 1000 2000 ?
  conform-action action when rate not exceeded

R1(config-subif)# rate-limit input access-group 100 8000 1000 2000

Is it a mistake in the practice?

Rgds,

Sergio Jiminez A.

• Next message: Bob Sinclair: "Re: IP Multicast over FR!!!"
• Previous message: MMoniz: "RE: IP Multicast over FR!!!"
• Next in thread: Bob Sinclair: "Re: QoS Task Question?"
• Maybe reply: Bob Sinclair: "Re: QoS Task Question?"
• Maybe reply: Sergio Jimenez Arguedas: "Fw: QoS Task Question?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:07 GMT-3