From: Michael Snyder (msnyder@revolutioncomputer.com)
Date: Wed Feb 25 2004 - 12:52:23 GMT-3
Well, if you are using more that 75% of the bandwidth value (per the
show int cmd) then you need to up the upper limit.
R8(config-if)#max-reserved-bandwidth 100
Which brings up a question,
Won't max-reserved-bandwidth 100 be a good default command to use with
MQC interfaces?
-----Original Message-----
From: alsontra@hotmail.com [mailto:alsontra@hotmail.com]
Sent: Wednesday, February 25, 2004 11:08 AM
To: SANCHEZ-MONGE,ANTONIO (HP-France,ex2); ccielab@groupstudy.com
Subject: Re: MQC for bandwidth reservation
Thank you Ato.
My question was more in regards of whether or not you have to specify
the
command when reserving bandwidth. I've seen MQC configurations with and
without the interface level bandwidth command. I think your saying that
I
only need to specify bandwidth if the reference bandwidth is different
than
the interface bandwidth.
Thanks
Alsontra
----- Original Message -----
From: "SANCHEZ-MONGE,ANTONIO (HP-France,ex2)"
<antonio.sanchez-monge@hp.com>
To: <alsontra@hotmail.com>; <ccielab@groupstudy.com>
Sent: Wednesday, February 25, 2004 2:29 AM
Subject: RE: MQC for bandwidth reservation
Hi Alsontra,
Both bandwidth commands have very different meanings.
Under the interface, it means the total reference bandwidth. Used for
QoS
but also for routing protocols, etc... Normally you need to change it in
serial interfaces where the real bandwidth is different from T1, etc...
Under the class in a policy map, it is the bandwidth you want to reserve
for
a particular class. The total reserved bandwidth cannot exceed by
default
75% of the reference bandwidth.
Cheers,
Ato.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
alsontra@hotmail.com
Sent: miircoles, 25 de febrero de 2004 11:01
To: ccielab@groupstudy.com
Subject: MQC for bandwidth reservation
When is the interface level bandwidth command used or needed with MQC?
For example:
class-map match-all ICMP
match access-group 101
policy-map ICMP_BW
class ICMP
bandwidth 128
interface fa1/0/0
bandwidth 1500 <-----------------------------When does this need to
be
specified?
service-policy output ICMP_BW
If I don't specify this, what value dose the interface policy use? The
interface bandwidth rate? And if so why would I want to change it?
Alsontra
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:56 GMT-3