From: Tom Lijnse (Tom.Lijnse@globalknowledge.nl)
Date: Wed Feb 25 2004 - 12:12:05 GMT-3
I was just notified that the link posted below requires CCO partner level access. I'm sorry about that. Luckily for all of you that don't have that particular level of access there's a link to the same tech note that does not require a CCO account.
http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a0080094694.shtml
(Basically it's the same url that I posted below, but with the '/partner/' removed).
Regards,
Tom Lijnse
CCIE #11031
Global Knowledge Netherlands
-----Original Message-----
From: Tom Lijnse
Sent: Wednesday, February 25, 2004 8:47 AM
To: William Chen; ccielab@groupstudy.com
Subject: RE: Traffic Generator in Real Lab
Hi William,
to generate TCP traffic you can use the undocumented "ttcp" command. This will allow you to transfer bulk TCP data.
It is somewhat documented in:
http://www.cisco.com/en/US/partner/tech/tk801/tk36/technologies_tech_note09186a0080094694.shtml
This tech note describes how to use a PC as the sender and a router as the receiver, but you can use a router as the sender as well.
Have fun,
Tom Lijnse
CCIE #11031
Global Knowledge Netherlands
-----Original Message-----
From: William Chen [mailto:kwchen@netvigator.com]
Sent: Wednesday, February 25, 2004 1:47 AM
To: ccielab@groupstudy.com
Subject: Traffic Generator in Real Lab
Dear all,
During the lab, if you are asked to configure QoS, you may need to
generate traffic to test your settings. Since there is not traffic generator
available in lab, what is the method you will use to generate traffic from
router to test your setting. I know that, "ping" can generate ICMP, "telnet"
can generate TCP, "traceroute" can generate UDP, do you know other ways?
Best Regards,
William Chen
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:56 GMT-3