DLSW Version 2 Multicast and UDP Unicast

From: William Chen (kwchen@netvigator.com)
Date: Thu Jan 08 2004 - 09:05:47 GMT-3

• Next message: istong@stong.org: "Re: dialer load-threshold"
• Previous message: Pun, Alec CL: "ip multicast rate-limit"
• Next in thread: Larry Clark: "Re: DLSW Version 2 Multicast and UDP Unicast"
• Maybe reply: Larry Clark: "Re: DLSW Version 2 Multicast and UDP Unicast"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear all,

    After I read the DLSW in the DocCD, in this link:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fibm_c/bcfpart2/bcfdlsw.htm#1002257.

    It states that DLSw Version 2 uses UDP unicast in response to an IP
multicast. Since both IP Multicast and UDP unicast are DLSW version 2
features. I wonder if Cisco use them?

    Moreover, the command "dlsw udp-disable" is available but don't not
configured as default. If DLSW+ doesn't use IP Multicast, why cisco enable
the sending of UDP unicast reponse as default? Should I disable it?

Best Regards,
William Chen

• Next message: istong@stong.org: "Re: dialer load-threshold"
• Previous message: Pun, Alec CL: "ip multicast rate-limit"
• Next in thread: Larry Clark: "Re: DLSW Version 2 Multicast and UDP Unicast"
• Maybe reply: Larry Clark: "Re: DLSW Version 2 Multicast and UDP Unicast"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:38 GMT-3