From: David Deng (glend_99@yahoo.com)
Date: Sun Dec 28 2003 - 03:48:48 GMT-3
Mike,
The other side is just the same except the ip address
is swapped.
R6-7200# sh int a2/0
interface ATM2/0
ip address 136.10.69.6 255.255.255.248
no atm ilmi-keepalive
pvc 1/100
protocol ip 136.10.69.9 broadcast
I could ping if the loopback addresses are shut on
both sides, so it should not be a misconfig of the
address.
Regards,
David
--- Mike Dickson <Mike@dicksonnetworks.com> wrote:
> Are you sure about your IP and netmask assignments?
> The 2 ends of the
> PVC aren't on the same subnet.
>
> Mike Dickson
> CCIE #12281, MCSE+Internet, MCDBA
> Dickson Network Designs
> (512) 422-3192 voice (512) 394-0320 fax
> www.dicksonnetworks.com
>
> -----Original Message-----
> From: David Deng [mailto:glend_99@yahoo.com]
> Sent: Friday, December 26, 2003 11:58 PM
> To: ccielab@groupstudy.com
> Subject: ATM PVC simple question
>
> Hi Group,
>
> Happy Holidays.
>
> Just have a qick question on the ATM PVC with
> loopback
>
> interface problem.
>
> When Simple config as such will not work as long as
> the router Loopback
> address is up,
>
> r9-7200#sh run int a2/0
> interface ATM2/0
> ip address 136.10.69.9 255.255.255.248
> no atm ilmi-keepalive
> pvc 1/100
> protocol ip 136.10.69.6 broadcast
>
> Here is the output of the debug on icmp while
> pinging from the neighbor.
> The echo-reply is returned to the loopback address
> of the neighbor, any
> suggestion on getting the ping to work w/o shutdown
> the loopback ?
>
> *Dec 26 20:33:50: ICMP: echo reply sent, src
> 136.10.69.9, dst 136.10.6.6
> *Dec 26 20:33:52: ICMP: echo reply sent, src
> 136.10.69.9, dst 136.10.6.6
> *Dec 26 20:33:54: ICMP: echo reply sent, src
> 136.10.69.9, dst 136.10.6.6
>
>
> Thanks,
> David
>
>
> __________________________________
> Do you Yahoo!?
> Protect your identity with Yahoo! Mail AddressGuard
> http://antispam.yahoo.com/whatsnewfree
>
>
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:45 GMT-3