From: Ken.Farrington@barclayscapital.com
Date: Mon Dec 01 2003 - 15:21:17 GMT-3
Hi Guys,
I beleive the basis of a hunt group setup is by using the preference
command. I hope this is correct.
I works fine using pots - from R5 I use the csim start
R3
!
dial-peer voice 1111 pots
preference 2
destination-pattern 1111
port 1/0/1
!
dial-peer voice 1112 pots
preference 3
destination-pattern 1111
port 1/0/0
!
now on R5, if I want to use a preference on the VOIP dial-peer, only so that
one peer goes to one loopback address on R3 and the other voice peer goes to
the second loopback address on R3 (imaging they are on different routers
completely but dont have the hardware for that) should this work? It says
in the docs, that this works for VoIP dial-peers ?
ie,
R5
!
dial-peer voice 1111 voip
preference 9
destination-pattern 1111
session target ipv4:192.168.3.3 (loopback 300 on r3)
!
dial-peer voice 1112 voip
preference 1
destination-pattern 1111
session target ipv4:192.169.3.3 (loopback 301 on r3)
!
Everytime I try this and debug for TCP/1720 it only goes from the
192.168.3.3 ???? Its a really old version of code, so if it is pss, i will
upgrade.
------------------------------------------------------------------------
For more information about Barclays Capital, please
visit our web site at http://www.barcap.com.
Internet communications are not secure and therefore the Barclays
Group does not accept legal responsibility for the contents of this
message. Although the Barclays Group operates anti-virus programmes,
it does not accept responsibility for any damage whatsoever that is
caused by viruses being passed. Any views or opinions presented are
solely those of the author and do not necessarily represent those of the
Barclays Group. Replies to this email may be monitored by the Barclays
Group for operational or business reasons.
------------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:34 GMT-3