Re: speed mismatch on frame multipoint sub interface and eigrp

From: pierreg (pierreg@mail.planetkc.com)
Date: Fri Jul 04 2003 - 11:02:06 GMT-3

• Next message: Scott Morris: "RE: Mobile IP configurations --- Mobile IP!"
• Previous message: pierreg : "Re: speed mismatch on frame multipoint sub interface and eigrp"
• Maybe in reply to: pierreg : "speed mismatch on frame multipoint sub interface and eigrp"
• Next in thread: Mike Williams: "RE: speed mismatch on frame multipoint sub interface and eigrp"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

No that did NOT work!

I am stuck!

Pierre-Alex

---------- Original Message ----------------------------------
From: "pierreg " <pierreg@mail.planetkc.com>
Reply-To: <pierreg@mail.planetkc.com>
Date: Fri, 4 Jul 2003 08:40:57 -0500

I have a simple question that is causing me lots of headache!

Please note there may not be a solution to this problem ...

---------------

R4 is connected to R1 and R3 via a multipoint subinterface

The PVC between R4 and R1 is 768 K

The PVC between R4 and R3 is 512 K

There is now way to put the two values on the multipoint subinterface.

So which bandwidth command should you use so that EIGRP computes

and advertise the metrics properly?

Thanks in advance,

Pierre-Alex

• Next message: Scott Morris: "RE: Mobile IP configurations --- Mobile IP!"
• Previous message: pierreg : "Re: speed mismatch on frame multipoint sub interface and eigrp"
• Maybe in reply to: pierreg : "speed mismatch on frame multipoint sub interface and eigrp"
• Next in thread: Mike Williams: "RE: speed mismatch on frame multipoint sub interface and eigrp"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:23 GMT-3