Re: speed mismatch on frame multipoint sub interface and eigrp

From: pierreg (pierreg@mail.planetkc.com)
Date: Fri Jul 04 2003 - 10:50:14 GMT-3

I think I may have a solution to my problem.

I will set the speed on R4 multipoint subinterface to 1544K
I will set the speed on R1 point-to-point interface to 768k
I will set the speed on R3 point-to-point interface to 512K

Given that EIGRP chooses the Lowerest bandwidth, the 1544K should be ignored and the value on the spokes will be used.

I will now be testing.

Pierre-Alex

---------- Original Message ----------------------------------
From: "pierreg " <pierreg@XXXXX>
Reply-To: <pierreg@mail.planetkc.com>
Date: Fri, 4 Jul 2003 08:40:57 -0500

I have a simple question that is causing me lots of headache!

Please note there may not be a solution to this problem ...

---------------

R4 is connected to R1 and R3 via a multipoint subinterface

The PVC between R4 and R1 is 768 K

The PVC between R4 and R3 is 512 K

There is now way to put the two values on the multipoint subinterface.

So which bandwidth command should you use so that EIGRP computes

and advertise the metrics properly?

Thanks in advance,

Pierre-Alex

This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:23 GMT-3