From: Chris McCoy (mccoy-cm@pacbell.net)
Date: Wed Jun 18 2003 - 01:43:10 GMT-3
Hi Tom,
It's confusing, but you specified your pri-group to be timeslots 1-24,
which corresponds to Serial1/0:0 through Serial1/0:23. The last DS-0 in
a pri-group is the D-channel, which is where most of your configuration
is. Cisco decided to make the timeslots command start at 1, and not
zero, since most other vendor's equipment works like this. Serialx/x:23
corresponds to Brix/x.
Chris M.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tom Young
Sent: Tuesday, June 17, 2003 6:44 PM
To: ccielab@groupstudy.com
Subject: pri interface config
Hi, group
Look the segment of a config sample, it is running in
a company of my customer, S1/0 is a isdn pri interface for user's
dial-in, it is working now. but, it said interface Serial1/0:23 , Why
0:23 ? Why use 23 ?
controller T1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-24
!
controller T1 1/1
!
!
interface Serial1/0:23
ip address 10.104.100.254 255.255.255.0
encapsulation ppp
dialer-group 1
isdn switch-type primary-ntt
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:11:00 GMT-3