From: Kris Minarcin (kristen.minarcin@digiconasp.com)
Date: Wed May 28 2003 - 02:04:49 GMT-3
Though this is a helpful new feature but be careful, this feature was added
in 12.2 (8) and since the lab IOS version is 12.1 I would hazard to bet that
this feature wouldn't be available in the lab....make sure you are familiar
with the older ways befitting the IOS version for the lab.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Cameron, John
Sent: Tuesday, May 27, 2003 5:08 PM
To: 'Songbin Wei'; Tom Young; ccielab@groupstudy.com
Subject: RE: isis sample
Songbin,
Actually, the network types for ISIS are P2P and Broadcast. There is also a
new feature that has been added that gives you the ability to change a
broadcast network type to P2P. See following link for more information:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122
t/122t8/ftissp2p.htm
HTH,
JDC
-----Original Message-----
From: Songbin Wei [mailto:sbwei_2000@yahoo.com]
Sent: Tuesday, May 27, 2003 4:24 PM
To: Tom Young; ccielab@groupstudy.com
Subject: Re: isis sample
IS-IS only has two network types: p-p and mp, and
there is no command like ospf to change the network
type, it's all pre-defined.
For FR main interface, the network type is mp, so if
the other end use sub-int, since its is-is type must
be mp, it must use mp sub-int, even it only has one
DLCI.
For is-is over FR, also you need to configure
'frame-relay map clns dlci# broadcast'
--- Tom Young <gitsyoung@yahoo.co.jp> wrote:
> Hi, group
>
> Who can give me a sample that one router use
> subinterface to connecting another one using phsical interface for
> running isis, as below
>
> RouterA S0.1---------------RouterB S0
>
> I couldn't make it out.
>
> Thanks alot
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! BB is Broadband by Yahoo!
http://bb.yahoo.co.jp/
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:49 GMT-3