Determine Custom Queue - Packet Size not known

From: badger (badger@pongo.org)
Date: Thu May 08 2003 - 11:38:10 GMT-3

• Next message: Yasser Abdullah: "RE: Bridge-group on a Tunnel interface?"
• Previous message: Scott Morris: "RE: ISL & Dot1q vlan"
• Next in thread: Brown, Patrick (NSOC-OCF}: "RE: Determine Custom Queue - Packet Size not known"
• Maybe reply: Brown, Patrick (NSOC-OCF}: "RE: Determine Custom Queue - Packet Size not known"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello ,

  My head is still spinning trying to decipher this from the archives.
   I have the following in my practice lab:

   Configure a custome queue and apply to T1 serial interface using the with the following information:

             Telnet traffic will use 15 percent of the bandwidth
             IP will use 45 percent of the bandwidth
             DNS will use 10 percent of the bandwidth

 How can I determine the queue byte counts if the packet size is not
 known?

-- 
Best regards,
 badger                          mailto:badger@pongo.org

• Next message: Yasser Abdullah: "RE: Bridge-group on a Tunnel interface?"
• Previous message: Scott Morris: "RE: ISL & Dot1q vlan"
• Next in thread: Brown, Patrick (NSOC-OCF}: "RE: Determine Custom Queue - Packet Size not known"
• Maybe reply: Brown, Patrick (NSOC-OCF}: "RE: Determine Custom Queue - Packet Size not known"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:38 GMT-3