RE: Determine Custom Queue - Packet Size not known

From: Brown, Patrick (NSOC-OCF} (PBrown4@chartercom.com)
Date: Thu May 08 2003 - 13:30:49 GMT-3

• Next message: FATHALLAH: "RE: Bridge-group on a Tunnel interface?"
• Previous message: Peter: "(no subject)"
• Maybe in reply to: badger: "Determine Custom Queue - Packet Size not known"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

maybe use default packet size! (20)

Thanks,

Patrick

-----Original Message-----
From: badger [mailto:badger@pongo.org]
Sent: Thursday, May 08, 2003 9:38 AM
To: ccielab@groupstudy.com
Subject: Determine Custom Queue - Packet Size not known

Hello ,

  My head is still spinning trying to decipher this from the archives.
   I have the following in my practice lab:

   Configure a custome queue and apply to T1 serial interface using the with
the following information:

             Telnet traffic will use 15 percent of the bandwidth
             IP will use 45 percent of the bandwidth
             DNS will use 10 percent of the bandwidth

 How can I determine the queue byte counts if the packet size is not
 known?

-- 
Best regards,
 badger                          mailto:badger@pongo.org

• Next message: FATHALLAH: "RE: Bridge-group on a Tunnel interface?"
• Previous message: Peter: "(no subject)"
• Maybe in reply to: badger: "Determine Custom Queue - Packet Size not known"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:39 GMT-3