From: kym blair (kymblair@hotmail.com)
Date: Fri May 02 2003 - 19:27:30 GMT-3
Vincent,
The "last hop router" config would go on the incoming interface. The
broadcast address statement in your config would reference the outgoing
interface (where the non-multicast-capable-hosts are located).
HTH, Kym
>From: "Vincent" <vvvwwbb@hotmail.com>
>Reply-To: "Vincent" <vvvwwbb@hotmail.com>
>To: <ccielab@groupstudy.com>
>Subject: IP multicast helper-map
>Date: Sat, 3 May 2003 01:55:58 +0800
>
>Hi group,
>
>After reading document from the follwoing link:
>
>http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fiprm
>c_r/mult/1rfmult2.htm#1089140
>
>I am in confusion about where to put the "Last Hop Router Configuration",
>i.e.
>on the last hop router's incoming interface or outgoing interface?
>
>Thanks for help!
This archive was generated by hypermail 2.1.4 : Mon Jun 02 2003 - 15:13:36 GMT-3