From: Hunt Lee (ciscoforme3@yahoo.com.au)
Date: Tue Mar 18 2003 - 10:24:05 GMT-3
Hi Group,
Does EIGRP has anything similar to OSPF / ISIS network types when communicating over
Frame-Relay?
R2 --- FR Switch --- R13
When do we need the "neighbor" command for EIGRP? Below is one example I found:-
On R2:
r2#sh run
Building configuration...
Current configuration : 140 bytes
!
interface Serial0
no ip address
encapsulation frame-relay
no fair-queue
frame-relay traffic-shaping
ip rsvp bandwidth 1158 1158
interface Serial0.2 point-to-point
ip address 150.200.16.2 255.255.255.240
frame-relay interface-dlci 101
ip rsvp bandwidth 10 10
router eigrp 1
redistribute ospf 1 route-map backtoEIGRP
network 150.200.0.0
default-metric 10000 1000 255 1 1000
no auto-summary
no eigrp log-neighbor-changes
And on R13:
interface Serial0
ip address 150.200.16.1 255.255.240.0
encapsulation frame-relay
frame-relay map ip 150.200.16.2 110 broadcast
router eigrp 1
network 150.150.0.0
network 150.200.0.0
distribute-list 1 in Tunnel0
no auto-summary
And even though that's the config for the e.g., I couldn't get EIGRP to establish
adjacency until I added the "neighbor" command pointing to each other. Hence, my
question is, did I missed something simple on the config, or do I need "neighbor"
statement whenever I configured EIGRP over FR?
Regards,
Hunt
http://mobile.yahoo.com.au - Yahoo! Mobile
- Check & compose your email via SMS on your Telstra or Vodafone mobile.
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:41 GMT-3