From: Khalid Ameen (khalid_ameen@rayaintegration.com)
Date: Thu Mar 06 2003 - 14:13:34 GMT-3
you can use ip ospf network point-to-multipoint without configuring any
neighbor command on R1
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Scot Peter
Sent: Thursday, March 06, 2003 6:39 PM
To: ccielab@groupstudy.com
Subject: A question on OSPF for NBMA Networks
Hi Group,
If we need to configure OSPF on a Multipoint interface with the
following condition,
- R1 should use Multipoint interfaces,
- R2, R3 should not use subinterfaces,
- All three routers should be in the same Network.
- Don't configure Network type Broadcast or non-broadcast.
R1
/ \
R2 R3
I am not sure about configuring "ip ospf network
point-to-multipoint" (as it is mentioned not to configure
non-broadcast) or do we need to configure using "neighbor"
command? Please advice me on this.
Thanks
Peter
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:33 GMT-3