Re: 2620 router problem, please help

From: Herve Bruyere (hbruyere@cisco.com)
Date: Wed Mar 05 2003 - 11:28:12 GMT-3

Are you sure you change back the speed of your teminal client as well??

Regards,
rv

Hunt Lee wrote:
> Does anyone out there knows how to set the config-register for Cisco 2620?
>
> I was doing an IOS upgrade for new flash so I change the baud rate to 115200 with
> the confreg command in BootROM mode.
>
> Now, my upgrade is done but the problem is I don't know how to set it back to the
> normal standard 9600.
>
> I tried that confreg command (in BootROM) as well as using config-register 0x2102...
> the router looks it boots up fine, but near the end of the bootup, it shows up a
> bunch of garbles... and I can't use the router ;-(
>
>
> rommon 2 > confreg 0x2102
>
> You must reset or power cycle for new config to take effect
> rommon 3 > reset
>
>
>
>
> cisco 2620 (MPC860) processor (revision 0x101) with 59392K/6144K bytes of memory.
> Processor board ID JAD043206M9 (2514823060)
> M860 processor: part number 0, mask 49
> Bridging software.
> X.25 software, Version 3.0.0.
> SuperLAT software (copyright 1990 by Meridian Technology Corp).
> TN3270 Emulation software.
> 1 FastEthernet/IEEE 802.3 interface(s)
> 1 Serial network interface(s)
> 2 Voice FXS interface(s)
> 32K bytes of non-volatile configuration memory.
> 16384K bytes of processor board System flash (Read/Write)
> X|<|[~`_|_vvXW;^[LvX+.WO[Lvim{LZ<,_L[,O6Zg;?&Z_2>Xi9:]
> ?Z?9[LCa^2aL^?{
>
>
>
> And if I rebooted my router and go back to BootROM mode, the baud rate has changed
> itself back somehow to 115200..
>
>
> Is there a command to clear the config-register value to its default?
>
> Thanks in advance,
>
> Best Regards,
> Hunt
>
> http://mobile.yahoo.com.au - Yahoo! Mobile
> - Exchange IMs with Messenger friends on your Telstra or Vodafone mobile phone.

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:32 GMT-3