From: Nawaz, Ajaz (Ajaz.Nawaz@bskyb.com)
Date: Wed Mar 05 2003 - 11:45:51 GMT-3
change the baud rate on your terminal emulator to 115200 in order to access
the 2600 once more.
After, go under line con 0 and set the baud-rate back to 9600.
ajaz
-----Original Message-----
From: Hunt Lee [mailto:ciscoforme3@yahoo.com.au]
Sent: 05 March 2003 11:47
To: ccielab@groupstudy.com
Subject: 2620 router problem, please help
Does anyone out there knows how to set the config-register for Cisco 2620?
I was doing an IOS upgrade for new flash so I change the baud rate to 115200
with
the confreg command in BootROM mode.
Now, my upgrade is done but the problem is I don't know how to set it back
to the
normal standard 9600.
I tried that confreg command (in BootROM) as well as using config-register
0x2102...
the router looks it boots up fine, but near the end of the bootup, it shows
up a
bunch of garbles... and I can't use the router ;-(
rommon 2 > confreg 0x2102
You must reset or power cycle for new config to take effect
rommon 3 > reset
cisco 2620 (MPC860) processor (revision 0x101) with 59392K/6144K bytes of
memory.
Processor board ID JAD043206M9 (2514823060)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
1 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
2 Voice FXS interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
X|<|[~`_|_vvXW;^ [LvX+.WO[Lvim{LZ<,_L[,O6 Zg;&Z_2>Xi9:]
Z9[LCa^2aL^? {
And if I rebooted my router and go back to BootROM mode, the baud rate has
changed
itself back somehow to 115200..
Is there a command to clear the config-register value to its default?
Thanks in advance,
Best Regards,
Hunt
http://mobile.yahoo.com.au - Yahoo! Mobile
- Exchange IMs with Messenger friends on your Telstra or Vodafone mobile
phone
**********************************************************************
Information in this email is confidential and may be privileged.
It is intended for the addressee only. If you have received it in error,
please notify the sender immediately and delete it from your system.
You should not otherwise copy it, retransmit it or use or disclose its
contents to anyone.
Thank you for your co-operation.
**********************************************************************
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:32 GMT-3