Re: Frame Relay

From: Vijay S Jayaraman (vjayaram@in.ibm.com)
Date: Fri Feb 21 2003 - 06:50:27 GMT-3

• Next message: Albert Lu: "RE: CCIE Gotchas: Watch out!"
• Previous message: Geoff Zinderdine: "Re: DLSW FST"
• Maybe in reply to: Bobby: "Frame Relay"
• Next in thread: Cassidy D. Smith: "RE: Frame Relay"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

A frame relay back to back should work....if you enable "frame relay
switching" on the dce side, add the "clock-rate" command on the dce
interface, add "frame relay intf-type dce" to the dce end and have the
DLCIs at both the connecting interfaces....

But I doubt whether you would ever have the oppurtunity to do this in an
actual lab because all the routers connect only through the frame relay
switch and you are not allowed to touch that.....

Regards,
Vijay.

                                                                                                                                       
                      "Larry Letterman"
                      <lletterm@cisco.c To: "Bobby" <bobby1@ctimail3.com>, <ccielab@groupstudy.com>
                      om> cc:
                      Sent by: Subject: Re: Frame Relay
                      nobody@groupstudy
                      .com
                                                                                                                                       
                                                                                                                                       
                      02/21/2003 01:02
                      PM
                      Please respond to
                      "Larry Letterman"
                                                                                                                                       
                                                                                                                                       

I'd be surprised if your config works..which one is the DTE
and which is the DCE..
I have a frame switch setup in my lab which works..and the
frame switch uses frame relay
routing and DCE/Clock rate commands..

Also the Lab as I understand it is already configured for
things like that..we should only have to configure the
routers that connect to each other..altho people have said
here and elsewhere that it might be in my interest
to know how to set up a frame switch...

Larry Letterman
Network Engineer
Cisco Systems

----- Original Message -----
From: "Bobby" <bobby1@ctimail3.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, February 20, 2003 6:01 PM
Subject: Frame Relay

> Hi Friends,
>
> If in the lab we were asked to configure a back to back fr
connection
> whether the following config is ok :
>
> R5
> interface Serial1
> ip address 200.100.2.1 255.255.255.0
> encapsulation frame-relay
> no keepalive
> frame-relay map ip 200.100.2.2 102 broadcast
>
>
> R6
> interface Serial0/0
> ip address 200.100.2.2 255.255.255.0
> encapsulation frame-relay
> no keepalive
> clockrate 64000
> frame-relay map ip 200.100.2.1 102 broadcast
>
> I was told that they will not accept the above config. Is
there
> any other way do it.
>
> Thanks

• Next message: Albert Lu: "RE: CCIE Gotchas: Watch out!"
• Previous message: Geoff Zinderdine: "Re: DLSW FST"
• Maybe in reply to: Bobby: "Frame Relay"
• Next in thread: Cassidy D. Smith: "RE: Frame Relay"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Mar 01 2003 - 11:06:31 GMT-3