ISIS

From: Jeffery S Kimes (kimes@us.ibm.com)
Date: Wed Jan 15 2003 - 02:31:50 GMT-3

• Next message: Yigit Zorlu: "RE: Call Manager redundancy"
• Previous message: Eric Foster: "RIP summarization with distribute lists"
• Next in thread: Aidan Marks: "Re: ISIS"
• Maybe reply: Aidan Marks: "Re: ISIS"
• Maybe reply: eric: "RE: ISIS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I've been trying to get a simple ISIS scenario working without much luck.

Basically, R1 is connected to R4 via a back-to-back serial cable. Here's
my configs...

hostname r1

clns routing

interface Serial0
 ip address 172.16.14.1 255.255.255.248
 ip router isis

router isis

=========================================

hostname r4

clns routing

interface Serial0
 ip address 172.16.14.4 255.255.255.248
 ip router isis

interface Loopback0
 ip address 172.16.4.4 255.255.255.0
 ip router isis

router isis

=========================================

Everytime I enter:
 net 49.0000.0000.0000.0001
in router 1 under router isis, I get the message:
%CLNS: System ID (0000.0000.0000.00) must not change when defining
additional area addresses, however, if I do a show running-config again
after entering the above command, underneath router isis, there is
nothing???

Regardless, when I do a show ip route, I do no see any ISIS routes :(

Regards,

Jeff Kimes
Senior I/T Specialist
I/T Consulting & Implementation Services
kimes@us.ibm.com
.

• Next message: Yigit Zorlu: "RE: Call Manager redundancy"
• Previous message: Eric Foster: "RIP summarization with distribute lists"
• Next in thread: Aidan Marks: "Re: ISIS"
• Maybe reply: Aidan Marks: "Re: ISIS"
• Maybe reply: eric: "RE: ISIS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:49 GMT-3