From: Brian T. Albert (brian.albert@worldnet.att.net)
Date: Thu Jan 02 2003 - 14:23:00 GMT-3
If you remove it, it will default to 120 seconds. Set it to it's max value
instead.
Brian T. Albert
CCIE #9682
brian.albert@worldnet.att.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Tim Fletcher
Sent: Thursday, January 02, 2003 10:38 AM
To: Evgeny Tantsura; ccielab@groupstudy.com
Subject: Re: ISDN Backup With Dialer Watch
This is usually caused by the idle-timeout on the far end (the end without
the dialer-watch). Try removing it and see what happens.
-Tim Fletcher
At 04:03 PM 1/2/2003 +0100, Evgeny Tantsura wrote:
>Hi,
>
>My ISDN interface with Dialer Watch on it
>is going down every idle-timeout and then dialing again.
>
>interface Dialer1
> ip address 1.1.1.2 255.255.255.0
> encapsulation ppp
> ip ospf demand-circuit
> dialer pool 1
> dialer idle-timeout 180
> dialer string 0496406937
> dialer load-threshold 127 either
> dialer watch-group 1
> dialer-group 1
> pulse-time 0
> no cdp enable
> ppp authentication chap
> ppp multilink
>end
>
>access-list 170 deny ospf any any
>access-list 170 permit ip any any
>dialer watch-list 1 ip 192.168.5.1 255.255.255.255
>dialer-list 1 protocol ip list 170
>----------------------------------------------------
>
>interface Dialer1
> ip address 1.1.1.1 255.255.255.0
> encapsulation ppp
> dialer pool 1
> dialer idle-timeout 180
> dialer load-threshold 50 either
> dialer-group 1
> no cdp enable
> ppp authentication chap
>
>dialer-list 1 protocol ip permit
>
>
>According to CCO it should stay connected until the router gets the
>route via primery interface.
>
>Any idea's ?
>
>With kind regards/ met vriendelijke groeten,
>------------------------------------------------
>E. Tantsura
>Network Developer
>Essent Kabelcom N.V.
>Dr.van Deenweg 84
>8025BN Zwolle, The Netherlands
>Tel: +31-(0)38-850-7642
>Fax: +31-(0)38-850-7410
>Mob: +31-(0)6-290-80458
>------------------------------------------------
>.
.
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:39 GMT-3