From: Jennifer Bellucci (Jennifer_bellucci@hotmail.com)
Date: Thu Dec 12 2002 - 19:12:18 GMT-3
I would agree with you but I have 2 VIC's in 2 different routers. I know
both of them are not defective, I thought about that as well. I think you
can rule out the hardware problem out.
Thanks for your thoughts...by the way, how did you get to your conclusion?
----- Original Message -----
From: "LRLab" <lrlab@swbell.net>
To: "Jennifer Bellucci" <Jennifer_bellucci@hotmail.com>
Sent: Thursday, December 12, 2002 11:13 PM
Subject: Re: VIC-2FXS Where's the dial tone?
> Bad VIC.
> ----- Original Message -----
> From: "Jennifer Bellucci" <Jennifer_bellucci@hotmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Thursday, December 12, 2002 7:56 AM
> Subject: VIC-2FXS Where's the dial tone?
>
>
> > Hello
> > I have a VIC-2FXS with a NM-1V on a c2620. When I connect the phone to
> port 1
> > I get a dial tone, no problems. When I connect the second phone all I
get
> is
> > air/no dial tone. On CCO they have written that port 0 use's US phone
> wire, so
> > I got hold of some and still nothing.
> >
> > The phones are new. Can someone tell me how in the blue hell do you get
> both
> > phones to get dial tone.
> > I tried connecting one at a time, same problem. Someone out there must
be
> > using both ports with phones connected right?
> >
> > I am based in the UK, if that helps.
> >
> > Appreciate the advice.
> >
> > Jennifer Bellucci
> >
> > Jennifer_bellucci@hotmail.com
> > .
.
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:44 GMT-3