VIC-2FXS Where's the dial tone?

From: Jennifer Bellucci (Jennifer_bellucci@hotmail.com)
Date: Thu Dec 12 2002 - 12:56:51 GMT-3

Next message: Jay Greenberg: "set-metric route-map with EIGRP"
Previous message: Hedi Abdelkafi: "Access-list with port monitoring"
Next in thread: Jennifer Bellucci: "Re: VIC-2FXS Where's the dial tone?"
Maybe reply: Jennifer Bellucci: "Re: VIC-2FXS Where's the dial tone?"
Maybe reply: Joe: "RE: VIC-2FXS Where's the dial tone?"
Maybe reply: Tim Fletcher: "Re: VIC-2FXS Where's the dial tone?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello
I have a VIC-2FXS with a NM-1V on a c2620. When I connect the phone to port 1
I get a dial tone, no problems. When I connect the second phone all I get is
air/no dial tone. On CCO they have written that port 0 use's US phone wire, so
I got hold of some and still nothing.

The phones are new. Can someone tell me how in the blue hell do you get both
phones to get dial tone.
I tried connecting one at a time, same problem. Someone out there must be
using both ports with phones connected right?

I am based in the UK, if that helps.

Appreciate the advice.

Jennifer Bellucci

Jennifer_bellucci@hotmail.com
.

Next message: Jay Greenberg: "set-metric route-map with EIGRP"
Previous message: Hedi Abdelkafi: "Access-list with port monitoring"
Next in thread: Jennifer Bellucci: "Re: VIC-2FXS Where's the dial tone?"
Maybe reply: Jennifer Bellucci: "Re: VIC-2FXS Where's the dial tone?"
Maybe reply: Joe: "RE: VIC-2FXS Where's the dial tone?"
Maybe reply: Tim Fletcher: "Re: VIC-2FXS Where's the dial tone?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:44 GMT-3