From: Joe Martin (jmartin@capitalpremium.net)
Date: Fri Nov 08 2002 - 13:41:43 GMT-3
Tom,
Straight from CCO EIGRP configuration Guide:
The connected keyword will permit the EIGRP Stub Routing feature to send
connected routes. If the connected routes are not covered by a network
statement, it may be necessary to redistribute connected routes with the
redistribute connected command under the EIGRP process. This option is
enabled by default.
See
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c
/ipcprt2/1cdeigrp.htm
HTH,
Joe Martin
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Tom
Young
Sent: Thursday, November 07, 2002 6:23 PM
To: ccielab@groupstudy.com
Subject: eigrp stub
hi, group
I tried the eigrp's stub command yesterday. For the
connected network, if I use the
eigrp stub connected
command , it should be distributed naturally into eigrp
AS. But I couldn't see the network from remote. Certainly
I set the command in a spoke router, and all of the
routers in the same AS.
Thanks
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:55 GMT-3