From: Joe A (groupstudy@comcast.net)
Date: Mon Nov 04 2002 - 12:10:36 GMT-3
Stop using HyperTerminal. This happens to me often; I just install
Reflections and have no problems. Sometimes HyperTerminal Personal
Edition fixes it, too. The HyperTerminal bundled in the OS is pretty
bad.
Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
jim.phillipo@guardent.com
Sent: Sunday, November 03, 2002 1:47 PM
To: ccie1@lycos.com; ccielab@groupstudy.com
Subject: RE: 2500 router problem
Try setting the console stop bits to 2
-----Original Message-----
From: ccie candidate [mailto:ccie1@lycos.com]
Sent: Sunday, November 03, 2002 1:13 PM
To: ccielab@groupstudy.com
Subject: OT:2500 router problem
folks ;
i have 2501 router has an interesting problem
when the router boots , it do not accept any command from the hyper
terminal ,however.
1-the boot process goes normally with all the messages shows on the
hyper terminal .
2- i changed the DRAM , Flash , bootRom with working ones ,however the
router still did not accept any command
3-when i send break signal , it breaks the boot process but again
nothing shows up when i type any char .
4-the hyperterminal settings is working fine with other routers .
the only thing i might think of is the value of the config-reg , it
might be something which dont allow receiving from the console ( just
guessing )
so is there anything ( like jumper on the main board ) i can do to reset
its value if this assumption is right .
otherwise what i miss here ????
regards
ccie
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:52 GMT-3