From: jim.phillipo@guardent.com
Date: Sun Nov 03 2002 - 15:47:17 GMT-3
Try setting the console stop bits to 2
-----Original Message-----
From: ccie candidate [mailto:ccie1@lycos.com]
Sent: Sunday, November 03, 2002 1:13 PM
To: ccielab@groupstudy.com
Subject: OT:2500 router problem
folks ;
i have 2501 router has an interesting problem
when the router boots , it do not accept any command from the hyper terminal
,however.
1-the boot process goes normally with all the messages shows on the hyper
terminal .
2- i changed the DRAM , Flash , bootRom with working ones ,however the
router still did not accept any command
3-when i send break signal , it breaks the boot process but again nothing
shows up when i type any char .
4-the hyperterminal settings is working fine with other routers .
the only thing i might think of is the value of the config-reg , it might be
something which dont allow receiving from the console ( just guessing )
so is there anything ( like jumper on the main board ) i can do to reset its
value if this assumption is right .
otherwise what i miss here ????
regards
ccie
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:52 GMT-3