From: Sam Munzani (sam@zealtron.com)
Date: Wed Oct 23 2002 - 21:38:51 GMT-3
Can you really do that on Serial interface? BTW, this is Frame to ATM inter networking. I think, I will end up setting up a 2 router lab with T1 cross over. Then set 1 side to AMI and other side to B8ZS. It should work(I guess:-)
I will let you know my findings.
Thanks,
Sam
>
> Sam,
>
> The most easiest way I can think of is to make both sides of the cable
> duplex mismatch. To simulate traps, you can enable either
> linkup/linkdown trap, if you have more than one interfaces to test, or
> syslog trap so that for each syslog message generated a trap will also
> be sent.
>
> Ming
> --- Sam Munzani <sam@zealtron.com> wrote:
> > Group,
> >
> > This is an out of topic item.
> >
> > I am testing some snmp scripts to watch CRC errors on serial
> > interface. What's
> > best way to simulate CRC errors on a circuit?(Other than configuring
> > wrong
> > Framing Type).
> >
> > also, I need to test my trap daemon for Envorinmental events. Any
> > easy way to
> > generate those events?
> > e.g. high temp events without putting router on a grill, Voltage
> > events
> > without short circuiting,
> >
> > Any help would be greately appreciated.
> >
> > Thanks,
> > Sam
>
>
> =====
> Mingzhou Nie, CCIE #10342
>
> __________________________________________________
> Do you Yahoo!?
> Y! Web Hosting - Let the expert host your web site
> http://webhosting.yahoo.com/
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:55 GMT-3