From: Donny MATEO (donny.mateo@sg.ca-indosuez.com)
Date: Tue Sep 17 2002 - 05:25:00 GMT-3
Hi Group,
I need help to clarify what is the difference between these two configs for DLSW direct
encapsulation :
dlsw remote-peer 0 frame-relay interface serial 0
int s0
frame-relay map llc2 131
and
dlsw remote-peer 0 frame-relay interface serial 0 131
int s0
frame-relay map dlsw 131
Solie says to use the latter for a multipoint interface. I tried the latter, but the state seems to
stay at disconnect. If I add the statement frame-relay map llc2 131, then it would become connect.
Any clue ?
tks.
Donny
This message is for information purposes only and its content
should not be construed as an offer, or solicitation of an offer,
to buy or sell any banking or financial instruments or services
and no representation or warranty is given in respect of its
accuracy, completeness or fairness. The material is subject
to change without notice. You should take your own independent
tax, legal and other professional advice in respect of the content
of this message. This message may contain confidential or
legally privileged material and may not be copied, redistributed
or published (in whole or in part) without our prior written consent.
This email may have been intercepted, partially destroyed,
arrive late, incomplete or contain viruses and no liability is
accepted by any member of the Credit Agricole Indosuez group
as a result. If you are not the intended recipient of this message,
please immediately notify the sender and delete this message
from your computer.
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:54 GMT-3