Stackable GBIC

From: David Bader (David.Bader@xxxxxxxxxx)
Date: Thu Aug 29 2002 - 03:54:47 GMT-3

• Next message: David Bader: "RE: Please confirm (conf#536511911095f5601509560edd6545d6)"
• Previous message: Khalid Siddiq: "RE: Again BGP sync/rid problem"
• Next in thread: Jay Hennigan: "Re: Stackable GBIC"
• Maybe reply: Jay Hennigan: "Re: Stackable GBIC"
• Maybe reply: Peter Mello: "RE: Stackable GBIC"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
hi group

i have a question concerning the stackable gbic.

according to cisco it is possible to stack a 2950 with a Catalyst 3550-12G
with this stacking GBICs.
on the 3550 i can route on every interface and therefore give an ip address
to every interface. right?
what about the interfaces on the 2950 (which is a layer2 switch) if it is
stacked with a 3550? can i route on every interface? can i at least trunk
vlan traffic over the stacking gbic and route between this vlans on the
3550?
thanks for your help.
regards dave

David Bader / Systems Engineer / NOS
CCIE #8645
-------------------------------------------------------------------
ECON!S AG / eBusiness Solutions
- Electronic Business Solutions
- Network and Office Solutions
- Consulting and Projectmanagement
Neumattstrasse 7 / CH 8953 Dietikon / Switzerland
Phone ++41 (0) 1 744 73 73
Direct ++41 (0) 1 744 73 25
Fax ++ 41 (0) 1 744 73 99
<mailto:david.bader@econis.com>
<http://www.econis.com/>
-------------------------------------------------------------------

• Next message: David Bader: "RE: Please confirm (conf#536511911095f5601509560edd6545d6)"
• Previous message: Khalid Siddiq: "RE: Again BGP sync/rid problem"
• Next in thread: Jay Hennigan: "Re: Stackable GBIC"
• Maybe reply: Jay Hennigan: "Re: Stackable GBIC"
• Maybe reply: Peter Mello: "RE: Stackable GBIC"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:41 GMT-3