From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Mon Aug 26 2002 - 20:45:06 GMT-3
Jim,
So a show run and see if you have ip routing enabled or disabled.
Regards,
Jason Sinclair CCIE #9100
Manager, Network Control Centre
POWERTEL
55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
email: sinclairj@powertel.com.au
-----Original Message-----
From: jim.phillipo@guardent.com [mailto:jim.phillipo@guardent.com]
Sent: Tuesday, 27 August 2002 09:01
To: ccielab@groupstudy.com
Subject: ustom Queuing question
It says on the Cisco DOC that you cannot use Queue 0 for traffic other than
the assigned system traffic.
Yet when I add the command :r3(config)# queue-list 2 protocol ip 1
Then do a sho run:
I get
queue-list 2 protocol ipx 2
queue-list 2 protocol ip 0 (what gives)
queue-list 2 default 3
queue-list 2 queue 0 byte-count 1000
queue-list 2 queue 1 byte-count 1000
queue-list 2 queue 2 byte-count 1000
queue-list 2 queue 3 byte-count 1000
Any thoughts ?
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:38 GMT-3