From: jim.phillipo@xxxxxxxxxxxx
Date: Mon Aug 26 2002 - 20:00:45 GMT-3
It says on the Cisco DOC that you cannot use Queue 0 for traffic other than
the assigned system traffic.
Yet when I add the command :r3(config)# queue-list 2 protocol ip 1
Then do a sho run:
I get
queue-list 2 protocol ipx 2
queue-list 2 protocol ip 0 (what gives)
queue-list 2 default 3
queue-list 2 queue 0 byte-count 1000
queue-list 2 queue 1 byte-count 1000
queue-list 2 queue 2 byte-count 1000
queue-list 2 queue 3 byte-count 1000
Any thoughts ?
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:38 GMT-3