1912 switch

From: Asim Khan (asimmegawatt@xxxxxxxxx)
Date: Tue Aug 20 2002 - 03:34:50 GMT-3

• Next message: thunai@xxxxxxxxxxxx: "Question on RIP"
• Previous message: Jason Sinclair: "RE: 1912 switch"
• Next in thread: Jason Sinclair: "RE: 1912 switch"
• Maybe reply: Jason Sinclair: "RE: 1912 switch"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi all,

I have a 1912 cisco switch which is giving me a
problem. When I start it up, it boots fine and passes
the post, after that I get two option as "K" or "M".

When I press M(main menu) it says "you can't go this
option because TACACS+ is enable", and after pressing
any key I get the same above two option(K and M).

When I press K(go to command line) and then press any
key it again comes to the same option(K and M). It is
doing this repeatedly and I am unable to configure the
switch.

Is the IOS has gone bad? I appreciate any advise.

Regards.

Asim Khan

• Next message: thunai@xxxxxxxxxxxx: "Question on RIP"
• Previous message: Jason Sinclair: "RE: 1912 switch"
• Next in thread: Jason Sinclair: "RE: 1912 switch"
• Maybe reply: Jason Sinclair: "RE: 1912 switch"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:30 GMT-3