From: EbonyGuru@xxxxxxx
Date: Tue Aug 06 2002 - 21:41:34 GMT-3
So which vlan address do you use for the bvi?
do you secondary address it from both vlans in the bridge group?
TIA
E'Guru
In a message dated 07/08/2002 01:04:24 GMT Daylight Time, bluspooky@yahoo.com
writes:
>
>
> You need to use IRB and assign the layer 3 address to
> the BVI. Use the bridge-group command on each
> interface that is part of the bridge-group and enable
> routing for the layer 3 protocol.
>
> --- EbonyGuru@aol.com wrote:
> > Hi guys,
> >
> > Do Ethernet interfaces and Trunking FastEthernet isl
> > subinterfaces on a
> > router doing irb need to share the same layer 3
> > address?
> >
> > I am asking this cos of scenarios where you are
> > bridging across multiple
> > vlans. Is a vlan not by definition a separate layer
> > 3 address space? If this
> > is so, how can you have them in the same bridge
> > group?
> >
> > TIA,
> > E'Guru
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:18 GMT-3