From: Imo Etuk (ietuk@xxxxxxxxxxx)
Date: Tue Aug 06 2002 - 23:51:31 GMT-3
Here ya go
conf t
(config)#int vlan x
(config)# ip address x.x.x.x y.y.y.y
(config)# no shut
exit
#vlan databse
#vlan x name ZZZZ
exit
(config)# int gig x
(config)# switchport access vlan x
(config)# speed x
(config)# duplex x
(config)# no shut
Thats all you need - hope this helps. I with these everyday :)
Imo
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ashok.Gupta
Sent: Tuesday, August 06, 2002 3:46 PM
To: 'Michael Snyder'; 'Todd Carswell'
Cc: ccielab@groupstudy.com
Subject: RE: Basic config of the cat 3550
conf t
interface Vlan1
ip address x.x.x.x y.y.y.y
Rem dot1q is default.
other commands need to know
switchport multi vlan x,y,z
switchport mode multi
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Michael Snyder
Sent: 06 August 2002 21:34
To: 'Todd Carswell'
Cc: ccielab@groupstudy.com
Subject: RE: Basic config of the cat 3550
Config t
Int vlan 1
Etc.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Todd Carswell
Sent: Tuesday, August 06, 2002 2:28 PM
To: ccielab@groupstudy.com
Subject: Basic config of the cat 3550
All,
Allrighty, I've finally got my paws on a catalyst 3550. I've accessed
the software config guide for the 3550 on the Doc CD but things just
ain't quite right!
The Doc CD instructs the user to access the vlan-config mode by typing
in the following global config command...
vlan <vlan id>
Here's what I'm getting from the switch...
cat3550(config)# vlan 100 ?
Unrecognized Command
I'm definitely missing a step. Could someone point me in the right
direction? I'm hoping that CCO has a page that walks the user through
some basic setup configs for the cat3550.
Thanks for the help!
Todd Carswell
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:18 GMT-3