From: Bates, Todd (todd.bates@xxxxxxxxxxxxxxxxxx)
Date: Mon Jul 29 2002 - 11:12:40 GMT-3
Error Message
Local Timeout (control reg=[hex]) Error, address: [hex] at [hex] (PC)
Explanation An invalid memory address is accessed, either because of a
software bug or because a boot of an incompatible software image was
attempted
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121sup/121se
ms/emdfail.htm
-----Original Message-----
From: NEAL COLLINS [mailto:nealc@maxsgi.com]
Sent: Sunday, July 28, 2002 5:10 PM
To: ccielab@groupstudy.com
Subject: Router Crashing
I don't know if anyone has run into an issue like this before. I have a
2500 Series router that when powered on goes into a constant rebooting loop.
I suspected that it might be a flash issue since when I pulled out one of
the flash modules, it stopped doing it. I replaced the module and reloaded
the IOS which is a 12.1 Enterprise with FW IOS. The router itself works
fine but if I turn the power off of it and then later turn it on again, it
will do this loop again. If I play around with the ROMMON mode and have it
do tests and so forth I can sometimes get it to boot properly again. The
problem occurs again every time I remove power from the router. I get the
following startup condition from the router when I turn it on:
System Bootstrap, Version 11.0(10c)XB2, PLATFORM SPECIFIC RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1998 by cisco Systems
2500 processor with 14336 Kbytes of main memory
Local Timeout (control reg=0x118) Error, address: 0x2130002 at 0x1010AA0
(PC)
If anyone has seen this situation before or has any ideas about what I might
be able to do to try to resolve the situation, I would really appreciate
your help. Thanks.
Neal Collins, MCSE, MCP+I, CNA, Compaq ASE, CCNA, CCNP
Max Systems Group Inc.
(416) 641-6616
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:48 GMT-3