From: Praveen Bahethi (pbahethi@xxxxxxxxxxxxxxxxxxx)
Date: Sun Jul 28 2002 - 18:48:59 GMT-3
Neal,
I believe you need 16MB of RAM for the code.
Check the on software center.
V/R,
Praveen
----- Original Message -----
From: "NEAL COLLINS" <nealc@maxsgi.com>
To: <ccielab@groupstudy.com>
Sent: Sunday, July 28, 2002 4:09 PM
Subject: Router Crashing
> I don't know if anyone has run into an issue like this before. I have a
> 2500 Series router that when powered on goes into a constant rebooting
loop.
> I suspected that it might be a flash issue since when I pulled out one of
> the flash modules, it stopped doing it. I replaced the module and
reloaded
> the IOS which is a 12.1 Enterprise with FW IOS. The router itself works
> fine but if I turn the power off of it and then later turn it on again, it
> will do this loop again. If I play around with the ROMMON mode and have
it
> do tests and so forth I can sometimes get it to boot properly again. The
> problem occurs again every time I remove power from the router. I get the
> following startup condition from the router when I turn it on:
>
>
>
> System Bootstrap, Version 11.0(10c)XB2, PLATFORM SPECIFIC RELEASE SOFTWARE
> (fc1)
>
>
>
> Copyright (c) 1986-1998 by cisco Systems
>
> 2500 processor with 14336 Kbytes of main memory
>
> Local Timeout (control reg=0x118) Error, address: 0x2130002 at 0x1010AA0
> (PC)
>
>
>
> If anyone has seen this situation before or has any ideas about what I
might
> be able to do to try to resolve the situation, I would really appreciate
> your help. Thanks.
>
>
>
> Neal Collins, MCSE, MCP+I, CNA, Compaq ASE, CCNA, CCNP
>
> Max Systems Group Inc.
>
> (416) 641-6616
>
> nealc@maxsgi.com
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:47 GMT-3