From: Darryl Munro (Darryl.Munro@xxxxxxxxxxxxxxxxxx)
Date: Fri Jul 19 2002 - 23:58:46 GMT-3
How is it possible to redistribute from OSPF to IGRP/RIP without using
statics to Null0? I know that the mask needs to be the same as the IGRP/RIP
domain, however is it achievable to do this with area range commands and
summary-address's positioned at the right the places in your OSPF domain?
Area range should take care of all of the OSPF inter area routes and summary
address the external addresses from other routing protocols. I just can't
seem to work this one out in my lab. Any suggestions would be appreciated.
TIA
Darryl Munro
CNE, MCSE, CCNP, CCDP, CCEA
Systems Consultant
Computerland NZ
104-106 Customs St West
PO Box 3631, Auckland
Phone: 09 306 8700
Cell Phone 027 2897786
Darryl <mailto:darryl.munro@computerland.co.nz> Munro
CAUTION: This e-mail message and accompanying data may contain information
that is confidential and subject to privilege. If you are not the intended
recipient, you are notified that any use, dissemination, distribution or
copying of this message or data is prohibited. If you have received this
e-mail in error, please notify me immediately and delete all material
pertaining to this e-mail. Ceritas / Computerland will not accept liability
for any loss or damage caused by using any material or attachments contained
in this message. While every best practice has been taken to, no warranty is
made that this material is free from computer virus or other defect.
Ceritas/Computerland's entire liability will be limited to resupplying the
material. Thank you
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:36:37 GMT-3