ISDN config in CIM

From: Peng Zheng (zpnist@xxxxxxxxx)
Date: Fri Jun 21 2002 - 16:49:27 GMT-3

• Next message: Jerry Haverkos: "RE: HSRP: the other side ?"
• Previous message: Carlos G Mendioroz: "Re: HSRP: the other side ?"
• Next in thread: Bezverkhi, Serguei: "RE: ISDN config in CIM"
• Maybe reply: Bezverkhi, Serguei: "RE: ISDN config in CIM"
• Maybe reply: Dan: "Re: ISDN config in CIM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi,

I'm using Cisco Interactive Mentor.

I remember I saw "isdn spid1" is necessary under bri
interface for ISDN.

But in the ISDN configuration of CIM, there is no
"isdn
spid1" configration under bri0, they use dialer map
with dial number instead of it. So it means "isdn
spid1" is not necessary.

I'm wondering when I should ignore "isdn spid1" .

Thank you for help.

Best Regards,
Peng Zheng

• Next message: Jerry Haverkos: "RE: HSRP: the other side ?"
• Previous message: Carlos G Mendioroz: "Re: HSRP: the other side ?"
• Next in thread: Bezverkhi, Serguei: "RE: ISDN config in CIM"
• Maybe reply: Bezverkhi, Serguei: "RE: ISDN config in CIM"
• Maybe reply: Dan: "Re: ISDN config in CIM"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:39 GMT-3