From: Fong, Eddy (Eddy.Fong@xxxxxx)
Date: Mon May 27 2002 - 04:04:06 GMT-3
Check the switch port security setting, if it's a Catalyst. I have seen this be
fore, when the cat port has been secured with a wrong mac address, this message
will come up no matter what you do on the router. Hope this help.
Eddy
-----Original Message-----
From: Nick Shah [mailto:nshah@connect.com.au]
Sent: Monday, May 27, 2002 2:25 PM
To: Tom Young
Cc: ccielab@groupstudy.com
Subject: Re: Message
Tom, the msg. usually indicates that you have not connected your Ethernet
port to anything (switch/hub/pc/another router etc). There are 3 things you
could do..
* no keepalive (but you said it doesnt work)
* shut down the port
* connect the port to switch/hub/pc/router etc.
Nick
----- Original Message -----
From: "Tom Young" <gitsyoung@yahoo.co.jp>
To: "Nick Shah" <nshah@connect.com.au>
Cc: <ccielab@groupstudy.com>
Sent: Monday, May 27, 2002 4:03 PM
Subject: Re: Message
> And I had done the no keepalive on ethernet port, but the
> message still come.
>
> Young
>
> --- Nick Shah <nshah@connect.com.au> $B$+$i$N%a%C%;!<%8!'(B
> > do a no keepalive in interface config mode...
> >
> > conf t
> > int e1
> > no keepalive
> >
> > hth
> > Nick
> > ----- Original Message -----
> > From: "Tom Young" <gitsyoung@yahoo.co.jp>
> > To: <ccielab@groupstudy.com>
> > Sent: Monday, May 27, 2002 3:01 PM
> > Subject: Message
> >
> >
> > > I always see a message on my 1600 router. I don't
> > want to
> > > see it again, how to do that?
> > >
> > > %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier.
> > Transceiver
> > > problem?
> > >
> > > Thanks
> > >
> > > Young
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:09 GMT-3